Thursday 26 May 2011

Ways How To Tune A Snare Drum Quickly Correctly

By Robert Scott


Snare drums are musical instruments which are made out of strands of curled metal or cables called snares that are then stretched over the head of a drum. Most drum enthusiasts consider the snare to be the drum kit's most important component due to its higher sound and ability to play a backbeat pattern. For owners who want to keep theirs in top playing condition, learning how to tune a snare drum would be a good skill to learn.

While it may sound relatively easy, tuning a snare drum can be quite difficult. It can also end fairly badly if it is not done correctly so be sure you are aware of all the steps before you attempt it. How you maintain and tune one will also depend on what it is made from, whether it be wood, aluminum, or other materials.

To begin tuning, start with the item's resonated head. It will most likely need to be tightened using the metal clasps on its side but keep in mind that the head's material is very thin and weaker than those of other drums. Make sure that it is centered before you tighten it and that you don't tighten it too much or it may tear.

Hit the drum's head and keep on hand on the lug for tightening to begin the tuning process. Use a special tuning device or your own ears. Ultimately, the sound and pitch you go with is up to you but, for snares, tight sounds are what you should aim for.

Once you are finished, turn the item over and tune the batter head, the side the drumsticks come into contact with, the very same way. Take the batter head and using the two-key method take the tension up in turns around two or three times depending on the item's size.

Check and be sure the head is evenly tuned across and then continue on with smaller turns. The major focus of the batter head is to get the right feel that you are comfortable with but think about the amount of ring you want your drum to have.

If the sound resonating from the item still just doesn't appear to sound tuned, it may be due to a number of issues. For one, the batter head may be screwed on too tight. The problem may also lie in the snare's wires, hit the head softly and listen for their rattling sound. If there are none, then they are fastened way too tightly.




About the Author:



No comments:

Post a Comment

Ex4.Me